I was able to catch a squirt out of the curenrt run during the switch from support to model material. It measured 0.013-0.014 which is what I would have expected from 85% Flow. When I just press Load' the free flow diameter was larger like 100% Flow leads me to belive the %Flow isn't working on Load' on my machine.I'll have to check on loading jogging I would think it would work.The 1st layer of model material at 85% Flow appeared almost as ruff as the 100% Flow. Also noticed the 85% applied both to model support (support looked better). I'm not going to have time to get the picture posted today. John
Comments:
I was able to catch a squirt out of the curenrt run during the switch from support to model material. It measured 0.013-0.014 which is what I would have expected from 85% Flow. When I just press Load' the free flow diameter was larger like 100% Flow leads me to belive the %Flow isn't working on Load' on my machine.I'll have to check on loading jogging I would think it would work.The 1st layer of model material at 85% Flow appeared almost as ruff as the 100% Flow. Also noticed the 85% applied both to model support (support looked better). I'm not going to have time to get the picture posted today. John